In the process of working with a grinder, a power drill or a screwdriver, one often encounters various problems: plastic chips stick to the inside of the angle grinder, it is not possible to unscrew the screws, because the edges are lined, when cutting tiles, dust settles on the case and clogs the ventilation grilles.
However, any problem always has a solution. Successful or not - judge for yourself. We bring to your attention three simple life hacks with a power tool that will help facilitate work in some situations.
Lifehack number 1
During the process of cutting the polypropylene pipes by the grinder, as well as various materials from plastic and rubber, a lot of “shavings” stick on the inside of the protective casing, which is then very tedious to clean off. To solve this problem, just stick a piece of masking tape on the casing. After work, the dirty strip is easy to remove, while the metal itself remains clean.
Life hack number 2
If you can’t unscrew the screws from the board or metal with a screwdriver due to the fact that the edges on the head are lapped, then a drill will help to solve this problem. Make a cut on the hat, then install a bit with a flat nozzle on the screwdriver or drill (or take an ordinary screwdriver) and unscrew the screws.
Lifehack number 3
When cutting ceramic tiles with a grinder, a lot of dust is formed, which settles on the body and clogs the ventilation holes. To avoid this, put a regular sock on the case for operation (you can use an old sock, but preferably without holes) - it will take the whole “blow” on itself. After cutting the tile, remove the sock and throw it in the trash.
